Results 1 to 2 of 2

Thread: Fast Idle for less than $20

  1. #1
    Join Date
    Sep 2009
    Location
    Chico, CA
    Posts
    29,847

    Default Fast Idle for less than $20

    I wanted a fast idle for my on board air to fill tires faster. So not wanting to spend much money on it, I just used some old Jeep parts. On the early XJs, there is a vacuum actuated high idle. It consists of an electrically operated valve and vacuum motor on the carb. The valve is found on the inner driver side fender right behind the washer bottle. It will have two wires that disappear into the harness and go to a pressure switch on the high side power steering hose. The purpose of the system is to give a 200 rpm increase when the power steering pump is pumping pressure.



    The valve is a special valve and is directional. The hose that points the same direction as the wires in the photo goes to the vacuum motor. It is normally open, allowing atmospheric air pressure to the vacuum motor and thus allow it to be in a normal state of rest. When closed, the atmospheric pressure is sealed off and vacuum goes to the motor and the plunger is extended. The plunger in the photo has been extended almost all the way allowing the full range of the motor to be utilized, about 1/2"





    Here is the vacuum motor attached to the throttle cable bracket on my Chevy engine. I used JB weld to attach the back of the motor. However there is a nut that goes on the large threaded portion that can be used if a bracket is fabricated. I welded a small tab on my throttle linkage to give the motor something to push against.

    So how well does it work? It is wired to my compressor clutch circuit. I get an engine speed of about 3000 rpms from it which allows my Sanden compressor to fill four 31" tires from flat to 35 psi in about 3.5 minutes
    Last edited by 4.3LXJ; 09-18-2010 at 08:05 PM.
    230 hp 4.3L Chevy
    Built 4L60E with manual lockout
    Atlas 4 speed
    Griffin radiator
    On board air
    Warn 9.5ti on custom bumper
    7.5" RE front and bastard pack rear on custom long arms
    30 gal gas tank
    lockers
    And a bunch of other stuff

  2. #2
    Join Date
    Jul 2010
    Posts
    154

    Default Re: Fast Idle for less than $20

    Nice.. I just use my hand throttle to do that
    87 XJ Chopped Locked Alloyed, Caged 3 linked W/doubler
    87 Free MJ Project
    90 MJ DD stock on 31's
    90 MJ Truggy 1tons, doubler, H1's on 42's

    Sheetmetal fears me

Similar Threads

  1. Fast Idle at Start Up
    By Jeepster19 in forum OEM/Factory
    Replies: 6
    Last Post: 11-25-2013, 07:45 AM
  2. Rough idle after startup
    By muddeprived in forum OEM/Factory
    Replies: 16
    Last Post: 10-28-2012, 10:25 AM
  3. fuel consumption on idle
    By oderdene in forum OEM/Factory
    Replies: 1
    Last Post: 01-09-2010, 04:09 AM
  4. Idle Stepper Motor & IAT
    By BlueXJ in forum 4.0 Liter Engine
    Replies: 0
    Last Post: 11-07-2009, 11:12 PM
  5. need help fast need to get on the road.
    By alwaysxj in forum OEM/Factory
    Replies: 10
    Last Post: 10-07-2009, 10:18 AM

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •