AXLE side of the upper control arm bushing

[XJ4IV]

I need help, Im going to fab up my upper control arm mounts for the axle side but I cannot figure out which bushing to get... I went to autozone today to check out the part listed as " upper control arm bushing" wellllll that being said OK but is that for the frame end or the axle end?... also what was the procedure for replacing em I was anticipating buying some DOM of the size that the bushing will fitt into and going from there... any fab advice is needed PLEASE!!!

[vwfoolwhy]

They are the same bushings. So yes it will work.

The best method for removing the old bushings is to use a Large C-clamp w/large sockets and odd exhaust pipe pieces or a Ball joint removal kit that can be rented at AutoZone for 20.00

[4.3LXJ]

Scott

They are the same bushing. However they are tapered. If you are fabbing, you can use almost anything. If you are doing a three link, the upper bushings are not tough enough. You would be better off using a lower bushing, they are much stronger and will last.

[XJ4IV]

well after talking with a buggy guru I was pals with in houston Im gonna do a three link using heims on both ends and have the third link centered on the axle!

[LizardRunner]

sounds like a great idea. I was going to suggest Johnny joints.