i just reinstalled my rocker arms and 2 of them have some play in them. i can move them side to side a bit. the rest of them are tight and wont move. is this bad?
Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Level: Cherokee XJ
rocker arm play
i just reinstalled my rocker arms and 2 of them have some play in them. i can move them side to side a bit. the rest of them are tight and wont move. is this bad?
Level: Jeep Wrangler
How much can you move them side to side? If they just wiggle a little its probably because the valves that belong to those rockers are probably closed so there's no pressure on them compared to the others which have pressure from the pushrods on them. I'm not 100% familiar with rockers on the 4.0L but if they have a torque spec, just torque them to that spec and if they move a little fine. I don't think you have to adjust them with feeler guages.
White 1991 XJ Sport - 4.0L, 5spd, 2-3" Spacer/AAL lift w/ RE shocks, 31/10.50r15 Cooper Discoverer STT's on 15x8 wagon wheels with 4" backspacing.
Alot More to come.
Level: Cherokee XJ
also i can spin the rods but 3 won't move.
Level: Jeep Wrangler
Do you have the service manual? Is there a torque spec for the rocker arm nut or do you have to set them up with feeler guages? if there is a torque spec (which I think there is), torque them down and they should be fine
White 1991 XJ Sport - 4.0L, 5spd, 2-3" Spacer/AAL lift w/ RE shocks, 31/10.50r15 Cooper Discoverer STT's on 15x8 wagon wheels with 4" backspacing.
Alot More to come.
Level: Hummer (H2)
just finished doing my 1999 4.0 and there is no adjustment possible. torque spec for retaining bolts is all there is! tighten em up and rock and roll
Posting Permissions
Reply With Quote
Bookmarks