Latest and Greatest from Ironman

[ironmanandy]

Wait hold up. There's been a lot of new stuff that we've come out with. Lets slow down and do a quick recap of what we got going on.


XJ Steering Box Spacer
- 49.95 Shipped gets you a beefy 3/16 box spacer with hardware. We also make one that works for Durango boxes. So if that suites your fancy, we got you covered.



http://www.ironman4x4fab.com/Steering.html









XJ Swaybar Drop Brackets
- With our steering box brace the stock swaybar doesnt quite clear the pillow block bearing bracing the sector shaft. We came up with a pretty sleek drop bracket so you can run your factory swaybar. 39.50 + 5 Shipping gets you the bracket with hardware.


http://www.ironman4x4fab.com/Products/XJ-SBDB-MOB.html









ZJ/XJ Steering Box Brace wtih Sector Shaft Support
- Probably the most sought after steering solution for unibodies, this brace knocks out 99.9999999% of steering box/body play. That annoying dead spot play in your steering wheel? Gone.. The results speak for themselves. 199.50 shipped for XJs and 249.50 Shipped for ZJs.



http://www.ironman4x4fab.com/Steering.html









Feel free to message us with questions, grab a quote, or place an order. We're here to help you with your world domination campaign...or just build a sick Jeep. Whatever you're into.

[Mudderoy]

Glad to see these new offerings Andy. I'm sure it was time consuming and risky developing them.

[denverd1]

Cool idea on steering gear box brace. Looks like a solid design. Im almost done bracing mine and wish I had known about it. Should be a good seller

Sent from my SAMSUNG-SM-G930A using Tapatalk

[ironmanandy]

Cool idea on steering gear box brace. Looks like a solid design. Im almost done bracing mine and wish I had known about it. Should be a good seller

Sent from my SAMSUNG-SM-G930A using Tapatalk

Thanks. What are you doing to brace your front end?

[denverd1]

front end frame stiffeners with big piece of steel running side to side right in front of the gear. need to put a tab on it then secure the gear. planning on a 2" muffler clamp secured to the tab. homebrew and probably not as secure as your approach, I really like your design

[ironmanandy]

front end frame stiffeners with big piece of steel running side to side right in front of the gear. need to put a tab on it then secure the gear. planning on a 2" muffler clamp secured to the tab. homebrew and probably not as secure as your approach, I really like your design

You can just buy our Pillow block bearing and sleeve nut to use for your own design if you're wanting to fabricate your own solid brace.

http://www.ironman4x4fab.com/Product...SSKIT-MOB.html

[denverd1]

You can just buy our Pillow block bearing and sleeve nut to use for your own design if you're wanting to fabricate your own solid brace.

http://www.ironman4x4fab.com/Product...SSKIT-MOB.html

So the nut on pitman arm is connected straight through the bearing. Great design. If my hack job doesn't work, I'll order yours.

[ironmanandy]

So the nut on pitman arm is connected straight through the bearing. Great design. If my hack job doesn't work, I'll order yours.

Sounds like a plan