Bushwacker flat fender flares , JCR lower rear quarter armor

[toledojeeper]

Installed some Bushwacker flat fender flares and so far really like them , install wasn't bad about 6 hours including a ride to get some bolts that were missing . Used a electric 3 inch cutoff wheel and it was perfect for the cutting , the only problem was rear lower quarters were rusted out and had no where to mount the lowest bolt on the fender flare retainers . I then ordered the JCR lower rear quarter armor to cover the rust and use them to mount the fender flare retainers . The armor is a pain in a to install on the drivers side but lucky the quarter was rusted so bad I could get my hand in there from behind the fender . Then I had to trim some of the fender flare so it would mount against the armor which is very thick . But it was a fun project and looks good with the rust covered , I did put some good rust inhibitor on the quarters before mounting the armor .