Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Level: Hummer (H2)
92 XJ code 35 won't go away
92 Jeep XJ - still throwin code 35 (bad relay) but everything seems to work - don't get it. Aux fan comes on with A/C and / or at about 240° 250° range. *new relay, new fan, new 20 amp fuse, new fan temp sensor.
One member suggested I disconnect the battery cables & and ground the positive and go thru a procedure but I couldn't find ground. Say Whaaat?
Super Moderator
Re: 92 XJ code 35 won't go away
Disconnecting the battery cables and touching them together will clear any codes. Also remember a code will stay there as a stored code until it is cleared manually or after 80 starts. What it is sensing is a bad connection in the coil circuit of the relay. Clean up the contacts and put a little dielectric grease on them and it should help
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Level: Hummer (H2)
Re: 92 XJ code 35 won't go away
Thank you sir- I get all skeet (ha!) dealing with auto electrics - don't want to screw nothing else up.
Posting Permissions
Reply With Quote
Bookmarks