Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Level: Hummer (H2)
Power steering problems
hi there new to the forum have a problem with high pressure hose from power steering pump as in the hose has a split in it and seeps fluid out I want to replace it with a flexible hydraulic line but nee to know pipe thread sizes anyone know where to get sizes from
Super Moderator
Re: power steering problems
The fittings on the ends use a compression O ring. The pipe end itself has to be made in a machine. The best you will do there is get one made at a hydraulics shop. It will be far easier to get a replacement line at an auto parts store
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Posting Permissions
Reply With Quote
Bookmarks