Ok cool. I think I will look into the 1 inch blocks.
Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Level: Jeep Commander
Re: Lift question...... Yes again.
Ok cool. I think I will look into the 1 inch blocks.
"If you do, I will"
Super Moderator
Re: Lift question...... Yes again.
I made mine out of 1/2X2.5" flat iron. Stack two, drilled in the center and attach them to the spring with the center bolt. Then they won't move around and are part of the spring
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Posting Permissions
Reply With Quote
Bookmarks