Fuel Pump wiring?

[Pookapotamus]

I am slowly getting Mort all wired up, and came across this problem a while back.

I have installed a larger Genright gas tank, this replaced the stock pump with a larger diameter one from a zj, (the one with the big 8" locking ring) now the wiring harness that I used from a 96 xj has 5 wires at the fuel pump connector, and the pump itself only has 4. so now what? I have had no luck searching through manuals, and Jenssen said there was a write up on here about this but I can't seam to find it.

so does anyone have any information on this??? any advice??

Thanks in advance, Pook

[NW99XJ]

Maybe this will help?

[4.3LXJ]

Ha, I see the difference now. The early gauges did not use the low fuel wire. There was a little circuit board that handled the low fuel light. If you eliminate that wire you have lost nothing since the low fuel light should still work

[Pookapotamus]

@ Josh, that might help, i will have to crawl under there and see. Thanks!