Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Level: Hummer (H2)
Lower control arm brackets bent,which is best to replace?
Hey all, I have a 98 XJ w/ 4.5" RE lift. My lower control arm brackets on the axle are pretty bent and starting to tear a weld from that last trip I took. I was looking at the Rustys or Currie weld on brackets. any thoughts on these? Do I need the cam adjustment still? It is a daily driver too. Thanks
Super Moderator
Re: Lower control arm brackets bent,which is best to replace?
Just about any of the builder parts will work. IIRC the cam adjuster is on the top, correct?
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Posting Permissions
Reply With Quote
Bookmarks