Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Level: Jeep Commander
WTB - XJ front driveshaft
I am soon to install a SYE on my 242 transfer and need a front driveshaft to modify for the rear.
The driveshaft will not be a direct replacement since I replaced my transmission with a 727 (behind a 318) and it will have to be shortened.
As I see it, any driveshaft with a good constant velocity joint would be usable (that is, from a Jeep).
I am located in College Station, TX 77845
Super Moderator
Re: WTB - XJ front driveshaft
Actually Ron, any drive shaft with Spicer 1310 U joints with a CV at one end should work. Jeep uses Spicer stuff for drivelines
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Level: Jeep Commander
Re: WTB - XJ front driveshaft
A Dodge friend found me a driveshaft at a pick and pull in San Antonio. It cost45.00 plus tax.
Super Moderator
Re: WTB - XJ front driveshaft
Not bad, take it
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Posting Permissions
Reply With Quote
Bookmarks