Tapatalk is active for this site! Just go to your phone's store to download and install.
|
Not registered as a member yet?
|
 |
|||
| Okay I get it you're not sure if we measure up yet. No problem look around and we think you'll find some good info and a lot of good people here all willing to help and not flame you when you ask a question. | ||||
 |
Level: Hummer (H2)
Loose Driver Window
Hello, greenhorn here.
My driver power window works well, except that when putting the window down, near the bottom, it starts to shake a bit. I took the door panel off and inspected. I have about an inch of play up and down, but all of the bolts looked tight and I cannot figure out where to adjust/tighten, or if that is even possible. Any help would be greatly appreciated.
Super Moderator
Re: Loose Driver Window
Just the window itself is loose up and down. All tracks and regulator tight?
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Level: Hummer (H2)
Re: Loose Driver Window
thanks for the reply, the tracks are all tight as far as I can tell. I do not know about the regulator, as I didnt know where to look inside the door.
Mall Crawler
I'm gonna say its a worn out window regulator. That would be my guess. Cheap to get at the junkyard but a PITA to replace
Sent from my nerdy smartphone
Super Moderator
Re: Loose Driver Window
I am thinking regulator too
230 hp 4.3L Chevy
Built 4L60E with manual lockout
Atlas 4 speed
Griffin radiator
On board air
Warn 9.5ti on custom bumper
7.5" RE front and bastard pack rear on custom long arms
30 gal gas tank
lockers
And a bunch of other stuff
Posting Permissions
Reply With Quote
Bookmarks