Search:

So today i decided id give it a try a i drove it about 30 miles with a few stops in between. It ran great and didn't hesitate to run or start. So i don't know if it was a freak accident or what, but...

Where can I get the codes pulled, I would normally do ot at school but I dont wanna risk having it stall on the highway.

I have a 96 Cherokee 4.0 auto. The other day I was driving when all of a sudden it started to sputter and the gas peddle had no effect. It then stalled in the middle of the road. It smelled of gas...

I know the voltage is good because the volt gauge is steady almost right at 14. And am i checking amps out of the back of the alternator, if so, which cable nd what amps should i get?

So what exactly should i be checking for?

How can i tell if it off whens its closed?

So is the reading im getting too high?

hood light was off, and now that i think about it the pins weren't deactivated lol thanks.

All of the light were off, and it is after market.

I have 96 Cherokee 4.0 auto manual windows and locks. A few weeks ago when I went to start my car for school my engine would barely turn over and the door buzzer was barely audible. I used a jump...

Do do i have to drop the pan, and if so how much of a pain in the ass is it?

I was looking around nd some people said you shouldnt change it thid late if it hasnt been changed before, is this true? I have put 3k miles on it since then and I dont know what fluids have been...

How hard is it to do the tranny, I have a good bit of tools nd take auto tech classes but how hard would it be to do that?

I have a 96 Cherokee, 4.0L auto. It just hit 160,000 miles and is still running strong. I know I have to change the oil but what else should be changed? (and what weights, brands, etc?)
Thank you,...

ok thanks, and i think i remember reading about the relays from the putco wiring harness going bad, could that make highs work but now lows?

No, I made sure i didn't.

Yeah it worked for about 2 weeks.

I have a 96 cherokee that i just installed healla housings with new bulbs and the putco wiring harness upgrade less than a month ago, but my problem is the passenger headlight only works when i turn...

How would i go about doing that?

Where do you get these switches from, I can't find them anywhere?

oh nice i just realized it was 5 amps at 125v, thanks a lot!

Yeah i just got a general pic from google, but does the switch need a certain amp rating or will the 5 amp Carling do fine?

If I can find a momentary switch like so, http://i1244.photobucket.com/albums/gg566/sshec152/momentary-action-push-button-switch-7208-2720757.jpg that would work I think I might have a really stealty...

What amp rating would the momentary switch need to be if i spliced it in with the ignition wire(blue)?

ok thanks anyway.