Search:

i was wondering what people are runnin tires, lift, axles.

that way if someone was trying to find a certain clearance or if they are tryin to find tire size they would know the clearance they...

i upgraded mine as well. i replaced the batt pos to starter, batt to alt, batt pos to distribution block, neg to body, neg to block all with 1g welding lead. everything runs so much better the lights...

i know a guy on naxja that needs the hatch struts. of your not on there pm with contact info and i will forward to him

as for 6" lift i ran stock control arms for a while on it. now i have short arms. i also know a good number of xj's with short arms with 6" lift. it can be done without probs. i do agree with the...

i would put a wing nut on that bolt easier to remove and put back on. dont have to pull out the socket set to do it

are you wantin full on mud? bfg also has some very good all terrains they are pretty good off road and have a great wear life.

Im runnin buckshot QR-78-15 measure 35.5x10.5x15, custom 6" lift, quaters and fenders trimmed, and have 12" clearence from ground to bottom of diff. I have HPd30 and d35.

Im tryin to find out what people have for diff clearence. There are 2 differant reasons. One is my own intrests and the other is for people tryin to figure out how high to go on a lift. That way they...

whats your goal on lift size?

front brake lines all you need to do is unbolt the hard line and bend it down. im runnin 6" lift and this worked fine for me. also the tj front lines will extend...

if you where to put bushings in both ends they would be just as road worthy as you stock ones and ride just as well if not better.

thats not necc correct. i have ran 33x12.5x15 on a stock tj wheel on my xj for the past 6 months or so. the tj wheel is 15x7. the only thing you have to do is get the correct tire pressure so the...

here are some at a good price.
carrier

this one is a bumper with carrier. shown for a tj same price for xj
bumper and tire carrier

looks good i have to do a new one for mine before ROM

think of it this way its harder to bend a piece of square tube then it is a round. you have 2 flat sides on the square where on the round there are really no flat rigid side wall. the long arms im...

page with .pdf file

Warning - You have to be a member to view this on naxja.

heres a link to move it up under the ac comp.

http://www.naxja.org/forum/showthread.php?t=1016319

there is also a .pdf file on there you can download

anyone goin to the ROM in gilmer tx?

i didnt know you where on here to xxmidianxx. hey my name is on there.

woohooo got a section for here. anyone else from here or close by?

i have 2 leafs from a k5 blazer. the second and third from the top on the k5 pack and have them in my # 2 and 3 position. i got between 3 and 4 in of lift pack is almost flat and flex's like crazy....

does any one know if these will fit on a renix model? i bet they would help alot with a stroker motor too.

most people that use tube on theirs use 2in dom tube. as with the ends find ones that are the same width as yours with the same size bolt hole dia. are you plannin on using ballistic joints,...

im runnin 33 and 410 its a major increase in performance, trq, and gas mileage. than the 355 i had.

how about one for Arkansas?

im on the same level as firehawk. to their own. i dont push my beliefs on anyone as i expect the same. its kinda odd though. my wifes father is a preacher. he is Pentecostal.