Search:

Bearings are shot in the third member so I pulled both axles and drive shaft, drained diff fluid.
Drove about 25 miles and now the wheel bearings are grinding and wheels wobble when lifted off the...

Can you run without axle shafts installed or do they support the wheel bearings?

thanks for the tips. I have to say it feels alot like its in 4 wheel drive trying to turn on dry pavement, I just got it licensed today so i've only been driving it around the lot. I'm going to pull...

OK, will have a look at the spacer, I'm thinking the alignment shop is not proficient with a straight axle jeep alignment, by the book isn't necessarily accurate for all xj's.

no play in steering linkage, had a person saw the wheel while checking linkage, it did appear the steering box shaft had some eliptical movement but just slightly, no leakage from the steering box....

while driving and just turning, it's fine going in a straight line.

Just purchased a clean low mileage xj sport. Steering is jerky, tries to jerk back and forth, not violently but annoying enough, new bfg's 235x15, alignment was done last DEC. Its not stuck in 4x4, I...

Heating cooling supply houses have the thermal limit for less than $2 with tax. If you can find a company to sell you one and you can get them in higher temperature ratings if you want. I raised mine...

My assembly shows no signs of overheating but the thermal element is open. Could even be some residual heat from the resistor after vehicle is turned off burning out the element over time?

Anyone know the temperature rating for the thermal limit on the resistor assembly. Some furnaces used to use them some years back. Might turn the resistor upside down upon re-install to keep some of...

Where is the location of the blower resistor?

Yeah I have a MF one. I ground a hardened torx bit to accept a 5/8 combo wrench, I put a 18" breaker bar on the box end and still can't budge the bolt. Would like to use some heat but a compartment...