Search:

Type: Posts; User: Crist Clapper; Keyword(s):

Page 1 of 12 1 2 3 4

Search: Search took 0.01 seconds.

  1. 1987 Jeep Wagoneer XJ Limited (Restored)

    https://bringatrailer.com/listing/1987-jeep-wagoneer-limited-3/
  2. Replies
    159
    Views
    44,604

    Punch List

    Working on the final punch-list:

    1) Cargo-area complete and vacuumed
    2) Power-seat controls - Recolored by www.fibrenew.com - NOS woodgrain applique
    3) Front-seat - Rear carpet covers
  3. Replies
    159
    Views
    44,604

    Re: 1987 Wagoneer XJ Limited

    Wanted to extend the roof-rack end-caps:

    1) Original end-cap
    2) Prototype - Bondo/spray-primer
    3) 3D of Prototype (UPS store)
    4) 3D sanded and Covered with chrome Vacucoat...
  4. Replies
    159
    Views
    44,604

    Re: 1987 Wagoneer XJ Limited

    Getting re-started again...



    This is a little-thing... But a lot of detail... And a bit boring too...:indifferent0020: The corners/tips of the lift-hatch were broken-off. Could have just hid...
  5. Replies
    159
    Views
    44,604

    Console:

    14715
  6. Replies
    159
    Views
    44,604

    Re: From Plastic to Plush :-)

    :rolleyes:
  7. Replies
    159
    Views
    44,604

    Re: 1987 Wagoneer XJ Limited

    :thumbsup:
  8. Replies
    159
    Views
    44,604

    Working on the trim (continued)

    Doing some fine-tuning... Was not happy with the seams.

    The solution:

    14692
  9. Replies
    159
    Views
    44,604

    From Plastic to Plush :-)

    Covering the plastic-parts is time-consuming. A lot of trial and error. I still have fine-tuning to do. In the meantime... Here are some pictures of the progress:
  10. Replies
    159
    Views
    44,604

    In search of the right power-seat-bezel - NOS or virgin condition

    In search of the right power-seat-bezel - NOS or virgin condition... Help?

    Example:
  11. Need NOS or Virgin Power-seat bezel (right-side)

    Example below:
  12. Replies
    14
    Views
    3,545

    Re: Unable to open hood... Help?

    Overall... Everything appears to move/release as designed... Until I shut the hood. Do you think by adding additional spacers it would reduce the tension so that the latches would open easier?
  13. Replies
    14
    Views
    3,545

    Re: Unable to open hood... Help?

    To re-test... I snapped pencils into the latches... Pull cable. Both pencils drop-out.

    I observe spacers under the latch/spring mechanism. What would be the result if I added addition...
  14. Replies
    159
    Views
    44,604

    Interior Panels

    Interior panels are covered with flex-carpet and ready to be installed:
  15. Replies
    14
    Views
    3,545

    Re: Unable to open hood... Help?

    More good advice... Thanks!
  16. Replies
    14
    Views
    3,545

    Re: Unable to open hood... Help?

    Finding this is a two-person job!

    So, I engaged a friend to pull/push the hood-release-handle. It appears that, although the cable is fully retracting into its sleeve, there's not enough pull to...
  17. Replies
    14
    Views
    3,545

    Re: Unable to open hood... Help?

    I hear ya... Compared to other Jeeps with the same... Too tight! :D
  18. Replies
    14
    Views
    3,545

    Re: Open!

    Hood-release is way too tight when re-opening the hood. Help?
  19. Replies
    159
    Views
    44,604

    Re: 1987 Wagoneer XJ Limited

    :cool:
  20. Replies
    159
    Views
    44,604

    Dash

    The dash is now reassembled. Radio in (power-antenna operational), and face-plate installed.

    Then... I stood-back and could still see some of the wiring under the dash. Used a piece of...
  21. Replies
    14
    Views
    3,545

    Open!

    - Removed the two bolts behind each of the headlights to release the two end latches.
    - Removed the skid-plate.
    - Slid a wooden-pole up between the fan and radiator, pushed up on the front-center...
  22. Replies
    14
    Views
    3,545

    Re: Unable to open hood... Help?

    Yeah... Both bolts are out. The hood have popped-up... But it didn't.

    I'm now thinking of removing the skid-plate... Reach up between the fan and radiator to release the center latch.
  23. Replies
    14
    Views
    3,545

    Unable to open hood... Help?

    I installed a new hood-latch-cable. Pre-tested its' operation. Shut the hood. Unable to re-open.

    Tried:
    1) Video on how to release the latches. I am unable to reach them because the skid-plate is...
  24. Replies
    159
    Views
    44,604

    Lift-gate Sill-plate

    It seems most of the used lift-gate sill-plates had scratches in the same place. I even purchased a NOS that then scratched in the same place.

    Concluded that the latch in the lift-gate with too...
  25. Replies
    159
    Views
    44,604

    Door-edges

    Back in the garage working again...

    Over the years the screws that hold the trim on the door-edges are either missing or the screw-holes were different sizes. As a result, I have various size...
Results 1 to 25 of 287
Page 1 of 12 1 2 3 4