Search:

Nothing like clean, tight and shiny. Nice job

Ha ha, you are working your way back. By the way, you can change that tcase input without a new bearing. Done that one. Keep up the good work

Just a suggestion on the dash. If you go 97+ you won't have a speedo and such. That is all drive by wire and you are getting rid of your ECM. You need to stick with the analogue gauges which you...

I used a Painless harness in my conversion too. It made it all much simpler

Pure beef there Zach

That was a good deal

You have your work cut out for you. Better get the big shoe horn out

That was a good deal for sure

Sounds like a good find for a parts rig

Just a suggestion on this Zach. It looks like someone has redone that track bar mount. Normally they go under the coil at the same height as the tie rod end. If you leave it there I would suggest...

Yeah that looks like it has seen some mud. After you get it together, make sure it dos not have slop in it

Lots of worthy projects for sure. On that track bar, looks like a Rancho set up on the springs and track bar. I am sure you can replace that joint

Ok, I am jealous