Search:

The earlier fuel rail will bolt right up. If you were to swap to the later fuel rail you'll also need to change the fuel pump and the fuel tank (the regulator was moved to the fuel pump assembly in...

Yeah, I it's pretty easy to do, but plan to install/remove at least three times going in. It's just all the adjusting length and such. I also did it solo, would have gone easier with a helper I...

Pop the range lever off the transfer case add the one ball joint to the new range lever first then up it goes. There is plenty of room for the rest. Keeping the interior handle in place was a hassle...

I finally bolted up my Boostwerks kit ... Should have done it sooner. Tcase shifts smooth as butter now. Something it hasn't done in three years now.

Sent from my SGH-I337M using Tapatalk

A dual Cardan yoke is about as easy to find as it gets ... Every jeep Cherokee, and Comanche since about 86-ish had one (there were a few rzeppa years). The front yoke from a 231J will bolt right...

You mean 7/16" by chance ... aka - 11mm as well.

Sent from my SGH-I337M using Tapatalk

A little late to the party ... but ...

You need to adapt the Renix TPS to the HO throttle body. I made my own, or you can buy one from Hesco. The IAC uses the same plug and works fine. The ECT...

The two piece manifold started with the 0331 head casting. The ports in the head were changed as well. Swapping the head requires the earlier manifold. The manifold was the same from 1991-1999.
...

A simple bracket is all it takes, made mine from aluminum strap obtained from the hardware store. All I used was a hacksaw and a hand drill. Hang the coil rail off the valve cover bolts (a couple are...

Thee later model valve cover uses a reusable rubber gasket, no cork at all. Do not use RTV, if it is leaking it is either loose or the VC grommets are old and cracked. The main gasket is pretty...

Any cylinder head from 91-95 (7120 casting) or 96-99 (0630 casting) will work. The earlier 87-90 (2868 Renix casting) can be made to work but really isn't worth the effort ... BUT ... you will need...

I've been running a 180 in my 2000 for about 8yrs now. Sits about the first mark before center. It will still run at full temp in the summer but does run cooler in the winter. Heater still cooks the...