Search:

ok so today i was reading through a forum not even closely related to this issue and someone mentioned something about an O2 sensor fuse... According to them it is a "little known fact" that xj's...

just ordered one for cheap. Hopefully that'll do the trick cause im wasting all my money on this "heep" ;):D

Yes it idles fine after it has its "fits". Every time I start it up after its been sitting for a little bit, it has somewhat of a difficult start(sometimes it starts just fine) and after a little bit...

ok so I just finished replacing the TPS as mentioned, and still no change.. :mad0090:

so far its been new plugs, new cap, new rotor, new wires, cleaned IAC, new TPS, new O2 sensors. I'm not sure...

So im looking to get the rough country 4.5' aal kit for my cherokee, which currently sits stock. The current Leaf springs on my jeep do sag about 1" give or take. My question is, will adding the AAL...

Just replaced the plugs a couple days ago. Ones I took out where actually not to bad, but they were Bosch so they are trash no matter what.

Ok that will be next after I get back in town after this weekend. Someone else said possibly a bad manifold and manifold gasket? My jeep does have an exhaust tick so this could also be the culprit....

After struggling to remove the O2 sensor for the last couple days (it was very stuck, and looks like factory, and my jeep has 178000miles.........) and installing a new one, the problem is still...

Yea sorry I forgot to mention no check engine light. I recently replaced the downstream O2 sensor but not the upstream. Maybe that's what's next then. I'll let you know if that fixes the issue....

When my jeep is at idle in park, it is idle-ing very rough. When I go to put it in drive and accelerate, it hesitates and the rmp's bounce around and jolts me forward and back, unless I step on it...

Ok I'm just going off what others have told me. I will definitely look into my exhaust more! But the noise sounds more like a metal-on-metal contact more than anything...

Just finished checking the flex plate. Everything was tight and couldn't see any cracking anywhere. Bent the hell out of the cover when getting it off so I hope I can force it back on :bang:.

Yea...

Pulled valve cover and checked rocker arms. All tight! I had someone sit in the drivers seat and rev it up while I was underneath and the noise is very loud bottom end as well as on top? I guess I'll...

Tried marvel mystery and ATF that was recommended to me, and there has been no difference

Thanks for the quick responses. Last time I checked the oil it was clean, but I will check it again and let you know when I can. And the noise definitely sounds top end. In the video, I hold the...

Hello, I'm new to the forum so this is my first post.

I just bought my first cherokee a few months ago and since i bought it, there has been a ticking/knocking noise coming from the engine. At...