Wait at least a few days before replacing anything.
We have had the MIL light go on and go back out in a few
days because of crappy fuel.
Tapatalk is active for this site! Just go to your phone's store to download and install.
Type: Posts; User: cyclone70; Keyword(s):
Wait at least a few days before replacing anything.
We have had the MIL light go on and go back out in a few
days because of crappy fuel.
I just did the hard lines on my wifes '96
3/16 brake line.
Wheel end fittings are 3/8-24
I just reused the fittings at the master cylinder end.
The master cylinder ends are 3/8-24 for the two...
The B&M Supercooler is a nice unit,much better than the old tube/fin style.
I put the same unit in mine a few months ago.
Installed it in front of the mechanical fan side of the radiator so that...
The 180 tstat has not affected the engine or mileage in any way over the last couple months,I may wish I had the 195 in when winter sets in.I think the fan switch,GC clutch,and trans cooler...
Sorry to join this discusiion so late.
I have a copper/brass Heatbuster 3 row radiator in mine.
Last summer during hot weather towing my bassboat(2300 lbs.) the temp
would run 220-230 with the a/c...
Ya ,what Roy said.
There is a power BUSS behind the dash that supplies all sorts of stuff with power.
If a sensor shorts to ground,the BUSS shuts down killing power to a lot of stuff.
Figured I would define what NO...
Back years ago when I was into CB, the unit to have was the President Jackson.
I'm sure they are pricey these days but they can really reach out there.
We were always running on SSB along with an...
Thanks,never knew that even though I had an '88 XJ
Beating the bolts from behind does work but you need to buy a socket to leave on the bolts.You will most likely trash the socket but at least not ruin the bolt heads.If the hub has been on for a...
OK,I'm a newbie here.
What does RENIX mean?
I keep seeing it over and over.
I agree even @ $250 it's still a great buy if it is a decent quality piece.
They look to be hand welded rather than crimped and epoxied.
I talked to a company that sells them.
They said they don't show them on their web site because they can't
keep them in stock.Right now the Champion web site shows them out of
stock too.
Anyone here own one.
Wondering how they perform?
thanks
This may have been talked about here before.
I ran into a No Start condition about a year ago.
Left my XJ ay his hous while fishing with him.
Returned from fishing,it starts and dies 3 seconds...
Turn on A/C and put a meter on the clutch coil connector.
I just replace one on mine recently.
Not a bad job,need a puller to get the pulley off.
Probably snap ring pliers too.
No tapping shaft...