Search:

LSD was always a factory Option in XJ. Never a "stock item+, if you have LSD it was added as an option by the original owner. That why you will see it decribed a some 4cy or some with tow package. ...

Same reasoning I use for Jeep repairs.

Thats the MRDS detector. Turn on the Auto Pilot system that causes the XJ to veer off the pavement, when it detects any Mud or Rock or Dirt or Sand.

Currently at 2" front and 3.5" rear. When I get a SYE, adjustable TB, and CA drops. I will put the 3.5" springs back into the front and Use the rest of my S-10 packs. Get it back to the 5", It had...

4.10 were used in 4 cylinder and early Up Country option, could also be ordered from the factory in all years. Jeep has always had many off the books options available. This is why it is almost...

It also requires the use or more oil to convert corn to fuel than is needed to make gas.

But, the worse thing is my Corn on the cob, also, cost more due to the reduce supply of corn.

I will never understand how using 20% more fuel, saves the environment.

I have the gauges needed.. I just don't want to do the job. This just gives me an excuse not too.

Because my pinion is to high... look at this picture, this is the correct orientaion, TC output and Pinion parallel, to pinion slightly 1-3 deg below TC. My TC is pointing at 4deg Down and my...

I'll ask at Napa when I pickup the Ujoints.
Thank for the confirmation on the bearings vs Spiders. Was my first thought, also. Might as well change, em, probably originals anyway. I know I...

Where do you get this Power Punch, stuff?
Me, too as far as vibes go. But there are none. And they were very minor even with the rear pointed 6 degs above the TC output. I'm now sitting only 1 deg...

IMO, there is nothing wrong with them. They just cast too much and provide no real benefit to an XJ motor. If a part doesn't work any better, why pay 3-4X more?

Neither really, Target height will be 3.5"-4", 4.5" max. I'm at 3.5" now with a Wrangler based bastard pack, (2 mains per side). I'm replacing that with a S-10 bastard pack. When I get the springs...

Well I lowered the pinion by 4 degrees, so if anything, the pinion is getting more lube. Level is good, and was changed, 2 months ago. Yes I have a 1" drop. Next week I am going to remove or reduce...

I shimmed my rear springs and now it Groans under power. I know I need a SYE but can't afford it now.

I had minor vibes so I checked my pinion angles. I could feel, but others couldn't. I added a...

Sorry, didn't catch that you were from the Netherlands. I have seen oil filter relocation kits or remote filter kits, I will post when I find again. One of these kits may allow the use of a deisel...

use several $2 walmart filters for the breaking period and a good filter later.

Is it closed system or open?

is the T-stat working, are the fan turning on when they should.

Do these work? Could be cheap aternative to scan tool? ...

IMO toss the relocators also and get some disconnects. If you plan on wheeling you will need them anyway.

They go in the front and throw the rear bar away.

No relegion, But the JEEP takes me to see Gods work every weekend.

It wont Hurt anything, as long as the 33" side of the axel can slip.

the green rig looks like its running wheel spacers probably 1-1/2" or so.