Search:

my 90 engine is getting a new head . It just so happens that my 95 head measures up exact and is already rebuilt so it will fit what I noticed was the 90 head gasket only had really small holes in...

would pcv being blocked cause enough pressure to blow the seal out

yes it fit just like the cam seals and they seam to be leak free they all sat a little deeper than the ones coming out but tight

i just replaced the front crank shaft seal on my father in laws 97 pathfinder 3.3 liter after everything was done it ran for 30 minutes perfect went for test drive and seal now leaks constant stream...

i have a 90 with an explorer 8.8 rear diff with a detroit locker 4.88 gears left rear seal is leaking down the inside of e brake down tire etc. how does one remove the c clips on the detroit to...

1990 hybrid 1995 lifted master cylinder from 95 doesn't fix hydrova on 90 i did't save hydrovac out of 95 it was shot anyway but my ??????? will a hydro vac from 95 fit in the firewall so iu can...

its stock steering box right now lol

cool thanks a lott!!!

do you know what years prior or did the change happen in 2000

having a rear brake probem as in there are none have bled 3 liters and no air my rear diff is out of a 90's explorer but not sure whatyear it has stock disk brake i need to know what years disc were...

managed to get 3 pics in albums 1990 finally lifted

how do you send pics

my 1990 is now a hybrid 1990 1995 lifted the 9 inch lift and 35 inch tires went in easy stock suspension came out without too much struggle the 95 tranny and tranfer went very difficultly but learn a...

will the input gears fit from tranfer case to tranfer case or do i need an adapter kit???

i am using a transfer case from a 1995 cherokee going into my 1990 cherokee but i think i have a 21 spline early model in jeep now and my 95 case has 23 i think is the output shaft on the tranny the...

i have a 1990 with the renix style i believe it had thae pressure tank rad setup i am going to put a 9 inch lift and diffs and transfer case onto it will the transfercase from a 1995 fit on the...

i was going to swap both diffs total suspension tranny bmount ant tranfer case hoping it will fit ?? does the tranny really need to be swapped as well

i have a lift 9 inch total lift from a couple of kits bolted to a 1995 or was bolted to it its now ready to go in 1990 is there any frame mods done between those years everything lines up and...

thanks i will check direction on pump replace tstat again and check on off cycles with temp gun to check gauge and sending unit

1990 had pressure tank with warped plastic lid that allowed system to overheat and boil over (big bloody mess everywere) swapped rad and overflow tank plus rest of hoses shutoff etc. from 1995 also...

having an overheating problem cracked head is suspected. I have a 95 head totally redbuilt ported etc. willit bolt on to the 90 block, both are multi port both apear the same externally is there any...