Search:

I also have A/C problems but mine will not blow out of the vents on the face of the dash just the vents that the defrost uses. I aslo can't get it very cold no matter how well it's charged. Any one...

It is a 3 link long arm. How would you rotate the axle? By adjusting the control arms, I am new to the suspension world. I wan't to make sure that my angle to the transfer case is still good...

I installed my sway bar back on my jeep with Rough Country quick disconnects. After I started to get every thing in place I noticed that my sway bar is hitting my drivers side spring. The spring is...

I have a 1990 XJ with 8 inches of lift, i have installed a slip yoke eliminator. I have it on Mickey Thompson Baja Claws. When i drive down the road it's so noisey that I can't hardly stand it. I...

Can any one tell me the symptoms of bad wheel berings? I jacked the wheel off the ground and tried to feel any thing loose, I couldn't find any thing.

I have a 1986 XJ with a 2.8L V6 it starts to knock when I acclerate. Once I get up to speed and more consistant RPM'S it seems to mellow out. Does any one have any ideal what might csuse this...

Thanks for the advice guys. I am going to get after it some time this week. Were supose to get a big snow storm tonight and tomorrow. I am over winter.

I am in stalling a Gobi roof rack, with Delta lights. I am looking for ideas on where to run the wires on the front and back. I want to make sure it looks good and is going to hold up to the...

I have a 1990 XJ it had a slip yoke eliminator kit installed. Since I have been driving it the speedometer doesn't work. I checked to make sure that the geer is in place on the out put shaft. ...

What all does it take to covert a closed system to a open system? Parts?

I have a 8.5 inch 3 link setup from Rusty's offroad on a jeep, could some one tell me if a three link is better that a Long arm. What is the advantages and disadvatages. Would it be better to do...

I don't have the V8 in this jeep that is my other jeep. This is one that I just bought, it has the 4.0 L I6.

It is a closed system, I was told that it has a new thermostat, I didn't check the lower hose. The two fans that are installed are on a manual switch, I think I am going to replace that setup.

I just bought a 1990 XJ with 4.0L, and it's over heating. It has two electic fans but. Still over heats and blows out of the resivor. Does any one have any ideas what might be the problem.

Has any one order a Rough Country 6.5 XJ Long arm kit, well if your planning on it I would, check other vendors first. I ordered one over a month ago and got every thing but my control arms, which...

I have a 1986 XJ with a weak 2.8L V6, I getting ready to start my build this week. I have purchased a rough country 6.5 in long arm kit,"waiting on the control arms acourse!" I have bought Mickey...