PDA

View Full Version : Aftermarket Gauges


msmoorenburg
04-26-2011, 09:55 AM
Ok lets post pics of where you mounted aftermarket gauges!! I'm kinda looking for a pillar mount since i'm doubting the factory gauges. I really don't want to drive around with my scanner hooked up :out:
Metlic53
04-26-2011, 10:47 AM
i have a 3 pillar gauge pod that i'm going to put in the white and purple jeep. I got it off of jegs. made for the cherokee.
Mudderoy
04-26-2011, 10:58 AM
i have a 3 pillar gauge pod that i'm going to put in the white and purple jeep. I got it off of jegs. made for the cherokee.

Part #, or link please....
Metlic53
04-26-2011, 11:09 AM
oops sorry its a two gauge pillar, couldn't find a 3 gauge one. Here is the link

http://www.jegs.com/images/photos/100/105/105-15210.jpg

http://www.jegs.com/i/Auto+Meter/105/15210/10002/-1
Mudderoy
04-26-2011, 11:13 AM
oops sorry its a two gauge pillar, couldn't find a 3 gauge one. Here is the link

http://www.jegs.com/i/Auto+Meter/105/15210/10002/-1

Would you mind posting a picture once you get it installed? I'm curious to see if the gauges will show at the correct angle.
Metlic53
04-26-2011, 11:16 AM
Sure, i'll probably get it in sometime this week and i'll post it up here :D
LizardRunner
04-26-2011, 01:56 PM
I'm having an issue with my alternator gauge, either the gauge is going bad or the alt. is going out, having a bit of tough time weather wise to check which it is right now. Question, will these gauges work as a direct replacement?
msmoorenburg
04-26-2011, 02:00 PM
I'm having an issue with my alternator gauge, either the gauge is going bad or the alt. is going out, having a bit of tough time weather wise to check which it is right now. Question, will these gauges work as a direct replacement?

Same issue here i was gonna wire it in parallel
LizardRunner
04-26-2011, 02:04 PM
Thanks for that tip. Yeah mine is acting like a squirrel. cold it doesn't register but if I restart once the engine is warmed up it works just fine. I hate it when that happens.
Mabey I need to see about just going all vdo gauges or auto meter
LizardRunner
04-28-2011, 08:10 AM
alrighty then, now the dang volt meter appears to be dead. I'll get the alt. checked then start looking for gauges if it isn't the alt. worst case, I'll be upgrading the alt.