Jeep XJ Door Sill Installation - Simple Stuff

[Mudderoy]

This is easier than putting gas in your XJ!

I ordered these on 11-04 and they arrived USPS 11-08. I purchased them from Howler_GT on CherokeeTalk.com.

They were packed well. All the edges were smooth to the touch. No cut fingers!!! Always a plus. I was concerned that they were not going to fit well enough to get the screws in straight, but all fears went away as I screwed it down.

This is a simple and inexpensive upgrade to your XJ which I recommend!

http://muckleroy.com/images/Jeep_sill1.jpg
Here is how it arrived (closed of course)

http://muckleroy.com/images/Jeep_sill2.jpg
Out of the package...

http://muckleroy.com/images/Jeep_sill3.jpg
Unwrapped

http://muckleroy.com/images/Jeep_sill4.jpg
Factory plastic sill

http://muckleroy.com/images/Jeep_sill5.jpg
Removal of factory Phillips head screws...

http://muckleroy.com/images/Jeep_sill6.jpg
Slide the plastic sill out of the way...

http://muckleroy.com/images/Jeep_sill7.jpg
Slide the aluminum sill in place (the screws will pull it down flush)

http://muckleroy.com/images/Jeep_sill8.jpg
Use the stainless screws supplied with new sills...

http://muckleroy.com/images/Jeep_sill9.jpg
Slightly different angle...

http://muckleroy.com/images/Jeep_sill10.jpg
Factory rear door sill. 2 screw removal, slide out and slide in the new sill.

http://muckleroy.com/images/Jeep_sill11.jpg
Driver's side complete. Again the stainless steel screws will pull down the sill

[Mudderoy]

Painted them black!

I used etching primer and then Plastikote bed liner.

165

And like a dumb a$$ I forgot about the ones beneath the rear doors! :timeout: :rotfl2:

[bluedragon436]

I will have to see if Howler_GT still does these sills... I am not usually a huge fan of Diamond Plate stuff, but I hate the cheapness look of the stock sills.. and they do look really good with the bedliner on them... You didn't forget the ones under the back door... You wanted to save that for another day of working on the XJ!! LOL