Activity Stream
-
Older Activity
-
9 Hours AgoThe CV isn't hard, you just have to know how to do it. There is a snap ring on the end of the shaft that is similar to the one on the end of my...136 replies | 8810 view(s)
-
15 Hours Agoyep I like a clean bill of health at wof time:bacondance: but have a funny crunching sound in the front right hub when in 4wd, and confirmed when...136 replies | 8810 view(s)
-
3 Days AgoHopefully that is it... I know mine is filled to just below the fill hole on the Solid cover, and as far as I remember the last time I looked it...23 replies | 204 view(s)
-
3 Days AgoSounds like not a whole lot to get her good to go with the inspection next go around... And sounds awesome on the shed/house front!!!136 replies | 8810 view(s)
-
3 Days AgoMe personally would go with the Hemi, but that's because I loved my Hemi, and would have loved to have had it in my Jeep... The 4.7 does have some...3 replies | 34 view(s)
-
3 Days AgoBoth are sensitive to regular maintenance. One issue particularly on the 4.7 is that they are put together with tight clearance. When they wear...3 replies | 34 view(s)
-
3 Days AgoThat is progress136 replies | 8810 view(s)
-
3 Days AgoCould have been it then I guess23 replies | 204 view(s)
-
3 Days AgoWell I drained about 3/4 of a quart out of the front diff last night. I believe its still overfull slightly, but its closer to the factory fill hole...23 replies | 204 view(s)
-
3 Days Agoit was going to the right? the same as you lot that drive on the wrong side of the road, :mel: But as mine is a jap import and the previous owner...136 replies | 8810 view(s)
-
3 Days AgoI've heard the 4.7 is fine as long as you do regular maintenance. I still like the 4.0l better, lol.3 replies | 34 view(s)
-
3 Days AgoOk guys, i know its an xj forum but im looking for some constructive input! My 2000 xj died. I gotta replace it but am not a good enough mechanic to...3 replies | 34 view(s) -
4 Days AgoI could say that was good "Yankee Ingenuity" but that is not going to work where you are. :D It would be better to say "Good Mongolian Ingenuity"...11901 replies | 1144917 view(s)
-
4 Days Agough, my 91 died while driving in traffic. Tried to start, cranking cranking, no start at all. Checked gas and it is there at port on fuel rail. Got a...11901 replies | 1144917 view(s)
-
4 Days AgoWrong light for NZ? How do you do that?136 replies | 8810 view(s)
-
4 Days Agowell bugger all done recently the water leak seems to be gone ....... still have a spare bcm oh and road legal for another 6 months, for the...136 replies | 8810 view(s)
-
5 Days AgoWelcome. Good looking rig.6 replies | 57 view(s)
-
5 Days AgoWelcome to the site! Mighty fine looking xj, although I might be a bit biased because it looks like my 92 Laredo when i got it. Looking forward to...6 replies | 57 view(s)
-
5 Days AgoIt turned out to be electronics, nothing with the TV cable or mechanical. I shift it with 3 rocker switchs on my center consol now. It works great...12 replies | 81 view(s)
-
6 Days AgoI use Isuzu rear leaves to make a bastard pack. Very flexible11901 replies | 1144917 view(s)
-
6 Days AgoThank you Sir!9 replies | 55 view(s)
-
6 Days AgoThank you9 replies | 55 view(s)
-
6 Days AgoGood looking XJ. Spacers and Shackles will be ok especially since you have newer leaves in the back.9 replies | 55 view(s)
-
6 Days AgoI would remove the thick overload, maybe replace it with the bottom leaf from the XJ pack? Or at least looking at the rear suspension pics you posted...11901 replies | 1144917 view(s)
-
6 Days AgoWe have a thread on here, "How to set driveline pinion angles" http://www.xjtalk.com/showthread.php?7299-How-to-set-driveline-pinion-angles If...9 replies | 55 view(s)
-
6 Days AgoCool, that front end was looking a little naked without it :D23 replies | 204 view(s)
-
6 Days AgoIt might be a pinion seal, but its hard to say. It only seems to leak on longer trips, or when im going 75 down the highway. I did find that the...23 replies | 204 view(s)
